i got my neighbour who is a hydraulic hose maker to make me some new fuel lines up.on the pump he used the old banjos as he couldnt get the right ones.on the pipe that feeds the fuel rail he wrapped electrical tape on the outside at each end,shoved it on the rail then put a crimp fastener on it on top of the electrical tape,on the return he did similar but with the wrong size hose,it went from braided to a 60 mm long piece of hose with a nipple joining them.when i took it to be tuned the guy said it was a fire risk and the rubber hose was leaking.basically it is a total arse and i knew it wasnt right from the start,where can i get the right ends from and does anybody know which size and type i need?cheers,lee