I have been look at injectors to use with my OFAB set up and i have a few questions to see if i am correct in what i am thinking.
They have different OHM`s, CC, Pressure (LB/HR)
(701s) 15.8 OHM`s, 226CC, 22LB

15.8 OHM`s = Power
226cc = Injector Flow Rate, Fuel amount
22LB = Injector Flow Rate, Fuel Pressure

(803s) 4.7OHM`s, 370CC, 35LB
So i would need to use a resistor to lower the OHM`s.
How about fuel pressure? 803 have a higher fuel pressure would i just use a higher pressure fuel pump? What about the fuel pressure regulator?

The above is purely an example as they run at different pressure and require different power, Its just to find out what i would need to do if i chose to use injectors above the 701s i have.
Cheers Stu
PS Hope i made sence