Welcome to the rsnissan auto jumble i will update this thread with new bits as i break the car further.

Standard Coil £10
Grp A leads only a few K's use £70
Standard Beru leads £40
Dizzy + phase sensor £20
Turbo Oil Feed pipe including adaptor £20
valve Stem oil Seals £40
Tappets Genune INA £40
PAS pump + Brackets £40
Polished stat housing and stat with take off for water temp gauge £30
Stainless lifting eyes £20
Water pump £30
TPS PFR8 £30
Mint Crank sensor £15

pics available on request for the above bits

FULLY aeroquiped breather £250
with welded on - 12 fittings going to both sides of the block with the correct adaptors to screw into the block on the exhaust side and push fitting to fit ion the inlet side and replace the kidney flame trap

Also a vent to atmosphere and a -10 return to sump (again proper threaded fitting)


Powder coated in a hard wearing "eggshell" finish black


3dr Header tank and swirl pot £150
With aeroquiped -4 for the swirl pot, a -4 blank (can be removed for water feed to turbo) and including a mint (rare) 3dr water level sensor also comes with roose motorsport hoses from rad to Stat housing and from the rad to swirl pot comes with brand new black cap, finsihed in black again eggshell finish


Washer bottle £75
With cap, level sensor (rare) and pump finished in black eggshell finish


PAS Tank £75
comes with new cap and finished in black eggshell finish powercoat











324mm Big brake conversion £500

Using 911 C2/Boxter S calipers been, Freshly refurbed and in porker boxes with brembo blanking plugs.

Brand new porker OE pads, retainers, pins, backing plates, mounting bolts

Brand new Focus RS OE Brembo discs. All that is required to fit these is a bracket (just knock one up in wood and get a machine shop to make for you) and some hoses to connect.






Grp A Throttle Bracket SOLD

Samco bottom water hose in Black £20 (bottom one in this pic)


Full Samco boost set inc stainless boost pipe £100



Early 2WD head needs an exhaust valve £350
includes everything apart from cams and tappets (can be supplied at cost)





Pair of BD10's £120 the pair





GL Spec Lamps SOLD

Chrome cam cover 2wd with breather take off £70


Turd coloured cam cover with breather take off £60


2wd Flywheel dont think this has been skimmed but can measure £60

2WD Engine Arms £20

Powdercoated cam pulleys £40 as above

ISCV £45


2wd throttle body inc idle screw £45 as above

black collins -31 actuator £40


2WD FPR £20