Originally Posted by
orionmojo
drivers side i have nothing. i've checked the fuses and pass side is fine. i have main beam on the drivers side but thats it. Is there an earth or something i'm missing?
remove connector and clean it with a bit of emery cloth and then close the gap abit to tighten connection should work ok if not swap the brown relays over and see
failing that get a multi meter and see if you get a reading try putting the earth to the body on a good point this should check the earth to light and on the connector try it from the back where its cripped and in the female spad the 2 side ones are main beam and side to top is high beam if i remember rightly if you have a good 12v try the bulb may look ok but you never know
mark2