Old Aug 25, 2008 | 12:55 AM
  #1  
xr4x4rs's Avatar
xr4x4rs
10K+ Poster!!
iTrader: (5)
 
Joined: May 2004
Posts: 10,574
Likes: 3
From: coventry
Default 4wd gearbox, b&m quickshift,avo coilovers

ok got these parts that imnot going use anymore, all have come from my car and in good working order

4wd gearbox, ran on silkoliene fully synthetic oil, no whines or crunches
has been modded to run reyland hydraulic conversion but still use cable aswell, as i need the hydraulic set p still, though i may sell, but i need to sort this part out first
has a new recon front prop that has had both ujs replaced and balanced up

£350







avo coilovers

need a clean, they dont leak, springs were re powdercaoted black, one of the rear adjusters has stopped working, and the spring platform is tight to turn, the rear platforms grub screws have been replaced with bolts as the plastic screws were naff

£250





b&m quickshift, in 4wd cradle with polybushes in, the gear changes were perfect and nice and tight, none of this hitting your hand off the handbrake lever like my old one lol, has covered 4k miles does have a few marks on it





£170

4wd rear uprated propshaft, its twice the size in diameter as a std one id say, mor elike a transit one where my propshft bloke made it for me when it had a new bearing fitted, comes with front part with doughnut which has 3 cracks in it, but never caused me any problems £100

another prop doughnut, im sure it has non or only 1 crack in it but will double check, £40

4wd cossie front calipers with black diamond discs and pads, covered 4k,no warping on the dscs and did there job calipers were reconned by big red 4k ago, and ive painted them silver as the road salt took the zinc off them £250 this is quarter what i paid for the complete set up, incs braided brake lines for fronts






4wd rear calipers, again same as teh front, black diamond grroved and rilled discs and pads, 4k miles, refurbed by big red again, in painted silver and braided lines, handbrake works perfectly

£200

4wd escort carbon heatshield, has done 2k, has holes in th ebakc for lambda and egt probe, bit you carnt see these when there fitted, has a mark on top where stut brace was rubbing on it

£160 cost me £250









need to get these gone asap as there taking up too much space in my garage and i need the funds to put towards a new car ive got my eye on

thanks

any questions please ask, can get pics if needed

also collection only, but will post brakes, cradle and doughnut, prop,gearbox and coilovers id like collection on or you send a courier

Last edited by xr4x4rs; Aug 25, 2008 at 01:28 PM.
Reply