got a few...

pedal box mounts back as it came off

erm.... ok ill start from the start with the best pics ive got


right... the T-piece and two male unions go to the FRONT master cylinder
the Female to female and two male unions goes to REAR master cylinder
and One male and one pipe union goes for the resevoirs.



then measure up how long you need the brake lines between these unions to fit between the pedal box and the standard capri locations and take em to a local garage n ask em to join them up by flaring the ends... like this..




use the blue n red things and a small bit of tubing to connect to the remote resevoirs.



then join these down to the master cylinders using the longer pipework



going through the old master cylinder hole!

running without a servo!! doesnt seem bad at all so far!