as title could some people give me an idea what these bits are worth please as im trying ot get as much as i can, but need an idea on these to see wether i build this engine again or buy one alreay done

heres the list

4wd cosworth head, ported and polished 26mm inlet/25mm exhaust ports, new style isky springs,bronze valve guides and stem seals 2k ago

std pair of cams

std pulleys

piper vernier pulleys in black, 2k old

200 block, .25th oversize, 6 wrc long studs, oil way blocked in block for 2wd oil feed only

t35/63.ex turbo, 2k old

4wd manifold, slight crack

4wd inlet, all new sensors, powdercaoted in black with new bolts and gasket

4wd thermostat housing, in black with new bolts

4wd water pump, 4k old

high pressure oil pump, billet type, 4 k old, 75psi constantly

4wd crankshaft, eith .25 all round or 25/std carnt remember lightened and balanced

4wd conrods with arp bolts, shot peened/polished and lightened and balanced

4wd flywheel, lightened and balanced
alcon clutch with uprated ap cover, done 4k

4wd bottom pulley no chips or missing teeth
distributor with new phase sensor

crank sensor

msd chip to run 7.2-1,55lb injectors, 3bar and t35

55lb seimens injectors

std fuel rail with ressure reg

grp-a spec-r bretaher system in blakc, with braided hoses and all fittings

4wd gearbox with reyland hydraulic clutch conversion

4wd carbon fibre heatshield, 2k old, has a rubbing mark where the strutbrace has been resting on it, and gold insulation a bit burnt by exhaust

front diff std

rear diff std

cosworth forged racing pistons, .2th oversize, 7.2-1 c/r done 4k, need new rings, rings can be bought from cosworth for around £120, these are £800 pistons otherwise

i may have some other bits that i have forgot about but this is the main lot

pics are in my resto section which is here, just have to have a look through,nearer the end

https://passionford.com/forum/restorations-rebuilds-and-projects/169740-rouse-style-xr4x4-cosworth-update-28-04-08-a.html

if some people can help me id be gratefull

other things may be like custom car looms engine loom, level 8 ecu, coil pack conversion et, but id like to try and keep these, but i dont know if there going to be needed, i need to see if this lot is going to help me out or not