i have a erst runnin gotech management, which i have to say jamie at jamsport did a brillant job fitting. but now i have realised the ignition amp must have been getting hot which is a bosch 6 pin amp, i orderd 1 up and they sent a 7 pin when i put it on the car it ran shit on idle, then i orderd a propper bosch 1 and again that caused it to run shit on idle even tho bosch say they are the same!? when i put the old 1 bach on it runs fine, but i would like to replace it as i has some meltin marks on it. i did realise that when it was put on the paste wasnt used, so i asume thats why it got hot! does any 1 have any ideas why this might be happening? your views are much appreciated.