Originally Posted by
Garage19
If the diff mount holes are an inch out i would be questionng the squarness of the whole car.
If i where you i'd flip the car on its side again and take some diagonal measurements between two major points eg front crossmember bolt and rear beam mount and check that opposite diagonals match.
Already checked that out Doug, its dead straight so thats no worry, just the bolt holes were about 25-30mm too far back, but we are using an aftermarket diff hanger so it may be that (although it came off my old saff?)
The offending cross member is being chopped out this week and plated up, so the prop should be mounted and the car might move under its own steam at the weekend!!!!!
