Originally Posted by
Gregor
Yess, if you use direct coil drivers you don't need the edis-module.
Can't run an efi car whithout cps signal..... so no..it's not running
I know you can't run an efi car whithout cps signal. All you said was....
Originally Posted by
Gregor
Well... my efi conversion is almost at a halt
Can't get an rpm reading but my cps is giving 2.5-3 volts when cranking...
What cps are all the zvh owners here using? the zetec or the cvh???
thanx
The car can run without an RPM signal out of the ECU to your tacho for example cant it, just not without a CPS signal.
Anyway,
Do you have it wired like this?
www.extraefi.co.uk
Do you have the CPS wired the correct way round and the shield in the correct pin?
I was sure they were both the same CPS but I'd only ever heard of people using the CVH CPS with the zetec 1.8 flywheel or CVH crank pulley.
If you'd used the EDIS module you could have had a better chance of troubleshooting it. The EDIS module can run the ignition without an ECU in a very basic "Limp home mode" so you'd know if your sensor and pickups were fine.
Other than that stick it on a stim and see what you get back!
Lee
