Originally Posted by jayRS
Converting an XR2i loom to OFAC
1) Pin no. 8 (brown) needs moving to pin 27, which is empty (CO adjuster signal wire)
2) Pin no. 27 (brown/yellow) needs moving to pin no. 45
3) EDIS Module pin 2 (blue/yellow) may now be disregarded as it is not used by the 0FAB ECU (pin 28 on ECU).
What are the EDIS pin 3? You mean the little 8 pin boks that translates the crankshaft signal to the ecu or something? That one over in the side of engine compartment.. Then there no lambda sensor but only the co2 adjuster..? Is that to adjust how rich the engine runs throuh the rpms or just at idle?
But many thanks for your description, it rocks!!
Grettings
Jesper Andersen