Hello

Im making a conversion on my escort cosworth involving a megasquirt ecu and a adaptor board to fit on the stock harness.
My problem is I connected everything like it should be but the engine wont crank at all.

It sounds like the fuel pump relay is coming in a few sec once i turn the key and goers off. I was wondering if it could be the pats module causing this problem, I have been told it would not cause any problem with pats as the ecu dont have to be recognized like a original ecu. Or is there maybe a wire that should be earthed that i didnt get? I have earth on wires: 16,20,40,46,49,60 in the ecciv plug

If anyone know where i can get a engine wiring diagram it would be mutch apreciated, i have been using one for the escort 1.8.