Okay in my quest to find a different (Read cheap) way of retaining the zetec fuel rail and use RST management, I have been searching high and low for Side-fed injectors that have 16ohm impedance and a suitable flow rate, but to no avail

What i have found is loads of Side fed injectors with very generous flow rates but slightly too little resistance, 15.6 ohms whereas i need 16ohms

What i'm wondering is if it would be possible to run a resistor of suitable resistance in-line with the injectors' positive lead to adjust the resistance???

I have seen this idea being mentioned on a website but could'nt find any specific details!


Cheers
Matt