Originally Posted by Chip-3Door
I wanted to do this using a calibra turbo gearbox and transfer box, turned 180 degrees so i have 6 reverse gears but then run an H22a honda engine that runs the other way around, but I was reliabley informed the helicals wouldnt like being spun backwards
Shame cause it would have been a doddle to do in my car and the gearbox is ideal cause it would end up rwd/4wd electronically selectable and also only normally transfer power to the front to pull out of a bend once the rear had started to slip.
ah well
but i was thinking of using 2x 2wd rear diffs, these could be turned upside down if need be to drive the corect way (still run in the same direction but will drive in opposite direction)