Welded the section of chassis rail in on Sunday, welding wasn't fantastic as the metal I was welding to was still a bit rusty (and I'm shit at welding ). It's a million times better than what was in there before though



I welded both sides but it was tricky to get the gun inside so it just turned into a big blobby mess





Oh well, won't see it again once the floor is down

We then started cutting out the nearside corner floor to see how bad it was.



You can buy that whole corner piece as a repair section but it's only the outer bit thats bad so we're going to weld in some more metal and leave it at that. Turns out it's been repaired quite extensively along the back before but it looks fine so we'll leave it.

Next job is to repair that corner and replace the floor then start on the other side


James