Originally Posted by rauri
Originally Posted by SafeChav
Just out of interest why have you removed the back box
was just wondering the same,and also why are you playing about with a bleed vavle when it comes across like you havnt a scooby do what you are doing?
sounds like a recipie for disaster
Erm, why don't I have a clue what I am doing?
I seemed to have lost a pound or two of boost, so I wound the valve out a little until I can get a new actuator. Surely the bleed valve does the same job as pre-tension on the actuator?
I do have a gauage and I don't let it go above 1 bar, which is safe as it's set to run 18psi.
And I took the backbox off because the weld around it had split and thought that, if a pressureless system wouldn't cause any harm, then I would just replace it with a piece of straight pipe.