Im sure this topic has come up many times b4 but as im kinda new 2 the site i need some advice on dump valves,

i decide a couple of months ago my engine bay was lookin a bit tatty n dated so i got on the phone 2 burton power n forkin out quite a bit of cash on a full set of brand new black samco hoses (boost and coolant),

After a lenghty wait cause samco didnt have any in stock the hoses arrived yesterday

It was like christmas had arrived all over agian only problem is their has been a mix up(or it was my fault) they have sent me a non dump valve hose from the intercooler 2 inlet


And i have the 90' elbow that goes from the filter 2 the turbo with a dump valve fittin


The hose from the air filter 2 the turbo dont really matter as i wasnt going 2 uswe this anyway,
Question is do i run my saph without a dump valve? or do i buy a ally T n cut my new hose up?