Mike can you look at my post regarding rear strut bars. Apparently the way that it is connected is not too good,

a.k.a wrote:
it would be easier to have one made than try to modify the ones shown.

Just think about it, imagine if you hold one end of the bar with a pair of fingers then hold the other end in a similar way

Now move one hand up upwards in an arc, as if the shock is being pushed up (or even downwards for chassis flex) whats to stop that happening - nothing, the bar certainly does not, as it will just swivel at the other end.

You need another fixed point along the axis line of the bar to stop the upwards movement, an easy way is a bracket from the bar down to the boot floot, bolted down to the floor, either centally or better still one in each corner about 20cms in from the mounting point on the shock

Even better is a bar coming off the same place as the mounting point on the shock down to the centre point of the main bar, at boot floor level - then another the same at the other end, then another bar where these meet on the boot floor going striaght up to meet the main bar - fully triangulated then.

Is this true and can you supply something that does the job?

https://passionford.com/forum/viewto...asc&highlight=


Cheers Mike

Luke