Originally Posted by JamboRST
Originally Posted by UnseenMenace
Originally Posted by davsmith64
if u want to run 14psi u will need the ecu chipped,,
unless u run a bleed valve but i advise u NOT to do this as mixture and fuelling will fuck up along with you engine..
Agreed.. Bleed Valves are the cheap way to increase boost however they do not adjust the fueling as well which can make the engine run lean and detonate.
A properly setup car has no need for a bleed valve
again you have posted this dribble,a bleed valve does not blows engines up,if raising the boost pressure by means of bleed valve or actuator will need the fuelling adjusted to suit extra boost,once air and fuel mixture is set up,a bleed valve will not give you any probs or blow your engine up,messing with it will just as messin with the actuator,so actuators must blow engines too,it will not detonate or fool ecu like you said in last post as the ecu takes its boost reading from the inlet,not the actuator/amal valve or any other place in the inlet
so how would you set your car up to run more boost on say std mfi management?wind the actuator right in to get desired boost
all i am doing is pointing out that bleed valves bypass the ecu from overboosting, also the std ecu and amal valve work with each other regarding fuel wise, but when bleed valves are there they are to easy to adjust boost!!! without one its set spot on and u cant mess!!! every time u adjust a bleed valve u will need a setup along with it!!!
ok if it was a choice between a amal valve and a bleed valve id deffo go for the amal valve!!!
i aint slaggin em off im just advising!!!