Hi i swopped my wiring loom over on the cossie to a Standard Loom (main car loom) And have thined it out alot This is all working in the car

But i have the 2 Plug set up for the ABS where as my ABS In the Cossie has just 1 plug Now i have the plugs off the other looms (IE the single plug and the other 2 plugs) as i was hoping to just rewire it into 1 plug BUT the wires are'nt the same

SINGLE PLUG WIRING COLOURS ARE ;

BLACK/GREEN , YELLOW , EMPTY , BLACK
BROWN/YELLOW , YELLOW , BLACK/BLUE , EMPTY

THE 2 PLUG SETUP

RED , BROWN/YELLOW
BLACK/BLUE , YELLOW

OTHER END OF THE PLUG IS THE SAME AS ABOVE,

THE OTHER PLUG

RED/BLACK , YELLOW
BLACK , BLACK/GREEN

OTHER END OF THE PLUG ONLY HAS 3WIRE SEE BELOW ,

RED/BLACK , YELLOW
BLACK , EMPTY

SO CAN SOMEONE HELP ME ASAP PLEASE

Just joined the wires up from the older ABS plugs to the newer ABS plug and i have found this

I seem to have a RED wire on one plug and a RED/BLACK wire on the other Plug (this is on the older ABS setup plugs) Theres no wires with these colours on the NEWER ABS setup Can i just leave them out