Is easy if your good with a welder and have about a weeks free time .

I had to make a jig up to ensure the brackets were welded in the correct position.
also the studs on the back of the servo are at a different centre to the original, so had to drill new holes and turn the brackets around to get the clearance.
I simply re-bent 3 of the brake pipes but one of them has a large fitting which needed cutting off and replacing with a small fitting and then flairing.

Pedal feels a lot better already and i aint had the engine running so servo is not working.

Hopefully exhaust will get finished tonight/tomorrow and i will get it back up and running.

Matt.