Hi all,
Not been on in ages as have been away working.

Will be able to give you an update on how things are going with my engine very soon as mine is due back on Harveys dyno again very soon.

Unfortunatly a couple of years ago when it was last dyno'd there we had a few isues as the company who made the inlet manifold made the back plate out of 2.5mm plate and not 5.0mm as we had specified.

It bent like a banana and we had a massive air leak!!
End of session!
Since then Ian has re-designed the manifold though.

In 2003 it made 325bhp and 321lb/ft at 3020rpm@23psi

Since then though it's seen some radical changes.

As soon as it's dyno'd i'll let you all know how it went.