Originally Posted by RS2300 4x4
Originally Posted by S1
Originally Posted by Lee Reynolds
You can get the required jig for this from most diy places, all you need then is a router.
Remember to cut in towards the laminate face at all times, this means machining some of the joints from the underside of the worktop. It is a lot harder to get a nice join than you might think especially if the room is out of square
Mark
Not sure what ya mean by that Mark. The room being out of sqaure doesnt affest the joint as the joint always goes sqaure with the units which are put in square. Any alterations are made to the rear of the worktop/units to get over the out of squareness.
Unless you fit the units out of square which is rough
