ok,

1st thing you have to do is change the front track, if you dont , all you will do is ..............................................hit the arb

loooks like we got that one

2nd, forget cosworth pas racks, the locks stops fook the job completely,

3rd - modify the existing steel xmember like so ...




you need to just drill two holes ( one on either side) not as i have done was development ) so 45 deg, 1.5" away from the std hole.

next select the rack, there many many variants of racks and arms/tre's

just take a look

tre's



and

steering arms



which items are the cosworth items

i mean - just how much lock do you want ???????????????????

its all in the track guys, you need to be seeing an increase of approx 3" across the front for this to work.

the racks are in all 2wd granadas, the lock 2 lock increases by 0.3 of a turn of the std wheel, from memory works out to 2.8 turns from lock 2 lock,

wheel selection is equally important, if you have the gayest offset going then your going to hinder yourself to start with, you may have to use spacers to sort your offset.

please dont tell me i need to tell you how to fit all this ?????


you may have to trim the section above the tca to enable full movement of the tca in its new position.



just off full lock