Not looking for "closed loop" arguements just the technically best product for money.
I know that its as much down to who and how its setup but would like to start with the best box for the money.

Comparing them - cant find too much info on T6 about resolution etc but offers some v good features such as multimaps etc for later.

T6 and Autronics both advertise knock control. I cant find anything about the autronic modules that are needed to run it?

T6 and Motec both run 32bit processers where as autronics is 16bit. Does this have a direct effect on resolution as the Motec has a higher Res than the autronics. The more Resolution the better i can only think.

With T6 you can get pectel to do you your cossie plug in brand new loom where as motec and autronics give you a kit - but wouldnt be too much bother.

Pectel seem to charge for software etc and may come out super expensive?

All seem to allow any injectors, "think" most can do fully sequential 8 injectors setups if wanted. All can do wideband, closed loop, boost control etc.

I have narrowed it to this 3 for support/reliability/availability in the UK. Was looking at other like AEM etc but dont trust reliability/service in UK etc

Again please dont shout pure results as that has many factors and all are used in a variety of fields very sucessfully

Thanks for any input from anyone that has experience with them.


Martin