Probably easier to post them up here
Box section going in to carry loom



Hole drilled in inner wing and loom fed through ,then special clips drilled in under lip of wing to hold loom up.

Loom passes around horns and pokes up for lights on o/s.


Then comes out of the box section ,around the washer bottle etc.


Fan loom going in.




Also lots of work done on the engine loom to hide that too.


Coil ,3 bar etc relocated to bulkhead ,to minimilise wiring on show.

Hope this helps ,not a five minute job as most of the wires need to be lenghtened,or shortened and also sleeved .