Originally Posted by FingerZ!
also i have been told its common for cossie engines to have some water wheeping out of the front corner by th eexhaust manifold on the head - is this right?
thinking that when i refit the head, sticking a bit of well seal on it to prevent this happening agia - i know if its skimmed etc it shouldnt happen again when torqued down properly, but i dont wanna have ot do the job again!
If you seal it, chances are you will have to do the job again sooner than if you did it properly in the first place
Good luck with the pulley, while you are waiting for a puller, etc... put loads of WD40 or similar on there to help it ease out.