A list of all the parts and prices can be found by clicking on the sig mate.

A loom to run Weber (Cosworth) costs me around £75 - 100 then i have to take it all apart and make if not only fit the ESRT/FRST engine bay but also make it look like it was ment to be there from the start. This takes quite alot of time to get right as some sensors need longer wires to connect to the loom, some shorter etc etc... All looms are checked on a running engine before they are sent out.

I will not have a loom just laying all over the engine bay getting wound up around the driveshafts

I charge £75 to do all the work on the loom (THIS IS NOT A QUOTE JUST GUIDANCE)

If you would like to use a coil pack, i install a custom loom from either pectel which will cost £150 or Ryan which costs £65 both items are spot on.

If you have any questions please ask.

Regards
Jano