At last theres an engine bolted in!!!!!!!!!!!!!!!!!!



Been a bit of a nightmare gettin it all done. DTA was binned for pectel T2. Engine was dynod at Harvey Gibbs by Ahmed, but the turbo I had only had a .36 exhaust housing so isnt really up to the job and now theres loads of end float. Made about 270bhp on the ickle turbo tho, so when a T34's bolted on we should get good power from it.

Thrown a standardish T3 on for now as cash has run low and were not spendin any more this year.

Just needs a pully makin up to pick up the alternator and water pump and loom a fuel pump and regulator now and were off.

Found out that cocksucker from BSW must have give me a second hand paddle clutch for the price of a new un cus its virtually dead and done no miles.

Not much room for the pulley in a festa!



Nor the downpipe.



Hopin to have it ready for Bedford in Feb.