Originally Posted by Micky
Originally Posted by vroooom ptssssh
the fixing that goes through the drain plug hole on the back of the spare wheel well, i used 2 large washers either side of it, a ruber grommit thing that was already there? and a long nut/bolt, hth somehow
I did more or less the same as vroom ptsssh,as the nuts and bolts holding the cradle to the car where seized solid,in fact both bolts sheared in half when I tried to remove the nuts off them!!!I just replaced the bolts and nuts and used the rest of the origional FORD rubbers,cradle etc.Regards Micky
Yes, but if his is anything like mine it was a nightmare removing the original cradle and mine looked shite and wanted the stainless jobby so out came the bolt croppers on my old one
