its a n/a zetec

so im using my standard xr3i ecu, my engine loom which i have changed to wires round because of sensors in different places

ive had a bracket made up so the throttle body will accepth the standard cvh tps

im using zetec crank sensor as the cvh is to long and got chewed up

and zetec injectors

standard xr map sensor

everything is as it was bar the crank sensor and injecters

i can get the car to fire up on the xr ecu

but it cuts out it wont tick over, this to me is its lean on start up

if i take the map sensor pipe off it will run but obviously at max fuel where its that much black smoke it burns my eye

im sorry if i sounded like im having a dig that it wont run cvh but i cannot find what i need to do

ive got to options now

either have a fuel rail made and some bungs into the zetec inlet so it will allow std cvh injectors

or get someone to wire me and zetec engine loom up

i rekon the 2nd option is the cheapest

as the throttle body to have modified just cost me 200 quid and i hate to see what a fuel rail and adptors cost