Radtec Intercooler.....RS500 ends....unfortunately inlet side end had been hacksawed to allow for connection to swedish plenum!!! Have got the end though to re weld back on!!!Not nessecary though imo.....£225

Std brand new radiator black ends with alluminium middle from Behr cost £170........£120 including fans

Engine........just head/block sump/pulleys/cambelt etc...done 2 miles since rebuild by myself and a PRO....if you stripped it and sold the parts individually you'd make money!

Spec......

7.9-1 comp ratio
Genuine Cossie racing forged pistons with cutouts .25
Std balanced rods
BRAND NEW cossie crank with std genuine bearings
Std oil pump
ARP big end and flywheel bolts
6 paddle clutch /h duty cover done 3000miles
2wd sump
EEC4 200 block with oil jets and WRC middle 6 long studded and liners
Cometic gasket set
WRC genuine 4 layer head gasket
Std water pump/2wd thermostat
Ported 2wd Head 26.5mm inlet / 25mm exhaust
BD16 INLET cam BD14 EXHAUST cam
Piper double valve springs
Kent Verniers
Grp A Cambelt

This engine was built to take 600 plus bhp(wether it would is another story !)...I have scrapped that and now able to offer this unique opportunity It cost near on 4k to do this spec with above parts...£2500 NO OFFERS it would cost you more to rubuild your OWN engine in std form from a pro!

PHONE 07759984033