Turbotodger

Hi all
my block on my cvh has cracked and was wondering if I could use the cvh pistons and rods in a 1.6 zetec so I could have a 1.6 zetec turbo
Thanks Shane

doga-ot

iTrader: (1)

Your better off sourcing another CVH block or if you set on zetec turbo your gonna have to dip in you pocket for new stuff bud!

Ben26

ive got a block, cant use the word fresh as its .25 oversize but has been bored honed and decked in very good nick if ya intrested

Turbotodger

Thanks but I already have one I was just wondering as I also have a 1600 zetec and was wondering if the internals would fit because I thort I might me a bit better as its a 16v

Ben26

This is the mentioned block

doga-ot

iTrader: (1)

even if they did fit bud it would be a complete waste of time going to all that effort of a 1.6zetec block when a 1.8 and 2.0 zetec blocks are peanuts to buy

Turbotodger

Fair point but all I thort was I have a 1.6 zetec and my cvh turbo block has cracked but all the lowcomp pistons and rods where there I need to rebuild it as its my daily and can't afford new rods and pistons on a 2.0 so why no go 1.6 16v just don't no if the rods and that will mate up to the crank