CAR MAD GAZ

Hi.

Whilst trying to take out my old temp sender I have managed to make a mess of it.

The old one looks like it has been replaced in the past and is stuck tight with red sealer and after several attempts to take it out I am left with just the threaded part in the head (with a hole through its middle where I have tried to use a bolt extractor).

I was thinking of putting a new thread through the centre of it and was wondering if anyone knows the thread size of a temp sender for an s2 (it is the one that fits into the head next to the thermostat housing)?


Many thanks in advance.


Gaz

RSmark84

M10 tap will sort it out.

studabear

I though the thread size was something like 1/8 npt??

RSmark84

I Used an M10 tap to make a clean thread the week before my post above. The new Temp Sender unit went in perfect.

Perfmr2

It is a 1/8npt, as Ive just finished doing my headgasket.

RSmark84

Either way M10 tap works fine.