Turbo Technics 2.8 V6 parts wanted
#1
Too many posts.. I need a life!!
Thread Starter
Turbo Technics 2.8 V6 parts wanted
Hello all,
Would anyone have, or could possibly make, a crossover pipe that runs from turbo manifold on nearside manifold to the off side manifold on a v6 2.8 engine. mine is damaged and i need a new one ready for rebuild.
Also could do with a new, or good condition intercooler if any available. has anyone modified one that will fit correctly.
Thanks.
Would anyone have, or could possibly make, a crossover pipe that runs from turbo manifold on nearside manifold to the off side manifold on a v6 2.8 engine. mine is damaged and i need a new one ready for rebuild.
Also could do with a new, or good condition intercooler if any available. has anyone modified one that will fit correctly.
Thanks.
#2
Too many posts.. I need a life!!
iTrader: (7)
intercooler
when i had t/t cars the intercooler always resembled the rs500 type-tbh any cossie one would suffice-but the bigger the better
the pipework will be hard to source unless somebody breaking exact car-then usually sold as a kit-sometimes with engine so you will probably have to adapt/fabricate this-shouldnt be too expensive if you ask about locally-even if you bend and cut your own pipes to shape and get somebody to weld a shoulder around it this does nicely
the pipework will be hard to source unless somebody breaking exact car-then usually sold as a kit-sometimes with engine so you will probably have to adapt/fabricate this-shouldnt be too expensive if you ask about locally-even if you bend and cut your own pipes to shape and get somebody to weld a shoulder around it this does nicely
The following users liked this post:
tonysierra4x4 (06-12-2014)
#3
Too many posts.. I need a life!!
Thread Starter
thanks tony66, i will measure up my old intercooler and try and get one the same as i can then use the original intercooler pipework which is new. it is the end pieces i realy need for crossover pipe as i was given the new stainless pipe without the ends on. i will try a exhaust manufacturer to see if they can get it sorted for me. was only quoted £340 for complete exhaust for my celica supra but never thought about asking them about the pipe. think it is old age lol.
#4
PassionFord Post Troll
iTrader: (2)
The end flanges are standard one side and very similar if not the same the turbo side so it's just a case of bending the pipe correctly then. I made one up on my old turbo xr4 as it had rotted but a decent exhaust specialist should make one for u cheap enough out of stainless. I recently sold a decent tt intercooler, typical still have pipes I think.
The following users liked this post:
tonysierra4x4 (06-12-2014)
Thread
Thread Starter
Forum
Replies
Last Post
muz
General Car Related Discussion.
3
16-08-2015 12:57 PM
155lee
Ford RS Cosworth Parts for Sale
0
14-08-2015 11:21 AM