Transitscott

Hi people having trouble programming a fuel pump on my 55 plate transit i start new session do a self test then I go to body>security>pats> module initialization>fip>incode then it starts to clear rim then turn the key on and off then it says incomplete please someone tell me where I am going wrong as I need the van for work and I won't have a job if not done by tomorrow

GVK.

where have you got your codes from?

Transitscott

Autokeyprog I got the incode from there the first time it said module reset compete but after that it says incomplete after it clears rim

GVK.

Sorry not familiar with autokeyprog, have only ever got codes from Ford through etis, I read your other thread https://passionford.com/forum/genera...-ids-help.html and it seems as though you followed the right steps.

Transitscott

I thought so but it doesn't work just wondering if I've missed something along the way

GVK.

The other thing is I've only ever fitted new pumps, but in theory when it does the clearing rim part it should clear an old pump.

GVK.

Might be worth asking on https://fordtransit.org/

I know it takes about 10 mins usually to clear the RIM, how's your battery voltage. Might be worth doing it with a charger on the battery.

As it's said it's incomplete I'm not sure whether you can re-use the incodes more than once?

GVK.

Me again lol.

I asked a mate I used to work with, he had similar once there is a 3 or 5 amp fuse in the engine bay fuse box that can blow to cause this also check wiring to pump he said.

Also make sure numbers on pump match as if they don't it's no good.