Fitting a Wrc bumper escort cosworth
 

How have people mounted they’re WRC bumper to escos ?
have a fibreglas bumper that i will put some work in and have it fit good and with a clean look without pin-locks. 😅

Anyone have any photos so i can take a look and figure out how its best to fit it ?🙂

thanks
joakim

Up....

I made brackets up to mount it at the sides and two at the front so I can take it off with just the removal of two bolts on the outside.

Ah ok, do you have any photos of it ? 🙂

Hi.

just like Markk said I did similar to mine fabricated two brackets to mount where the original bumper sits in the chassis legs marked in the picture and carbon fibre them into the back of the bumper and made side brackets at the wings which are holding up the bumper to get a good wing gap and held in with a stud on the lip running down each side of the bumper so nothing visible as in my other pic as you can see hope this helpshttps://cimg3.ibsrv.net/gimg/passion...04142f55df.jpg
https://cimg1.ibsrv.net/gimg/passion...df02bd9178.jpg

https://cimg9.ibsrv.net/gimg/passion...b45efe155f.jpg