compression stoke rotor points cylinder 4
#1
15000
Thread Starter
Join Date: Feb 2011
Location: darlington
Posts: 30
Likes: 0
Received 0 Likes
on
0 Posts
compression stoke rotor points cylinder 4
rebuilt engine at tdc rotor points to cylinder 1 crank at tdc turning clock wise inlet valve opens then at 180 crank tbc compression rotor points to cylinder 4 i,ve done some wrong but dont know what it is or how to cure its a cvh rs 1.6 havent tryed to start think that would bend valves help plz
#4
15000
Thread Starter
Join Date: Feb 2011
Location: darlington
Posts: 30
Likes: 0
Received 0 Likes
on
0 Posts
This link shows a later 1.4 but the cam timing is the same as any other CVH
http://workshop-manuals.com/ford/fie...r/timing_belt/
http://workshop-manuals.com/ford/fie...r/timing_belt/
Last edited by nelly345; 30-03-2014 at 08:17 PM. Reason: wrote wrong info
#5
15000
Thread Starter
Join Date: Feb 2011
Location: darlington
Posts: 30
Likes: 0
Received 0 Likes
on
0 Posts
just been in garage to look after setting up both cam and crank at tdc 12 oclock rotor on no1 turned crank 1 turn inlet valve opened and closed crank now at tdc 12 oclock cam at 6 oclock rotor pointing to cylinder 4 i,m thinking take belt off turning crank 1/4 turn then turn cam 1 full turn or until rotor points to 1 again then put crank to tdc and put belt on but not sure
#7
15000
Thread Starter
Join Date: Feb 2011
Location: darlington
Posts: 30
Likes: 0
Received 0 Likes
on
0 Posts
i think so to first time i,ve come across it i had to send head away it came back unset not sure how many times to turn the cam to reset it from 180 out or if it can make cylinder 2/3 wrong if i sus out to get no1 right or 2/3/4 fall into place?
Trending Topics
#8
15000
Thread Starter
Join Date: Feb 2011
Location: darlington
Posts: 30
Likes: 0
Received 0 Likes
on
0 Posts
it was 180 degree out it starts now and runs hard to start turns over and over rumbling then runs rough how do i get it to true tbc it carnt be on compression stroke odd thing is with crank 1/4 turned belt off turned cam to fire stroke no1 could not get it go on right of the cam it starts at 6 oclock finishs at 12 oclock tdc i have to take head off again to change a bent valve witch was bent when head gasket went but it didnt get changed in the garage when i sent head to get welded and skimmed kicked in the balls again i didnt think it got one of the valves but i was wrong
#10
15000
Thread Starter
Join Date: Feb 2011
Location: darlington
Posts: 30
Likes: 0
Received 0 Likes
on
0 Posts
didnt know it was bent when gasket went there was no tapping noise and sent head to garage to get welded and skimmed stem seals oil seals done at same time guess valves werent checked heads back off now so i can get knew one now
Thread
Thread Starter
Forum
Replies
Last Post