Subaru EJ20 CDB bottom end
#1
Subaru EJ20 CDB bottom end
I have my spare closed deck block bottom end for sale.
This was removed from a 95' RA, was stripped and reassembled as a spare.
Had acl race series bearings fitted. crank on std grind. pistons std size. new oil seals gaskets etc.
This can have a set of heads fitted, or used as the basis for a big bhp build.
£450 ono plus postage. or can collect from near perth,central scotland.
Fraser
This was removed from a 95' RA, was stripped and reassembled as a spare.
Had acl race series bearings fitted. crank on std grind. pistons std size. new oil seals gaskets etc.
This can have a set of heads fitted, or used as the basis for a big bhp build.
£450 ono plus postage. or can collect from near perth,central scotland.
Fraser
#3
No, not new. After stripping,
the block was cleaned up
Pistons, rods, crank checked
Reassembled with new ACL race bearings, new crank seal etc
and hasnt been ran since.
But no, its not a 'new build' per say.
It is however the ideal basis for a forged big bhp build using the cdb & sell off the orig crank rods pistons etc.
Hope this answers your question.
Thanks
the block was cleaned up
Pistons, rods, crank checked
Reassembled with new ACL race bearings, new crank seal etc
and hasnt been ran since.
But no, its not a 'new build' per say.
It is however the ideal basis for a forged big bhp build using the cdb & sell off the orig crank rods pistons etc.
Hope this answers your question.
Thanks
Last edited by Fezman1; 02-11-2014 at 02:50 PM.
Thread
Thread Starter
Forum
Replies
Last Post
SMILER258
Restorations, Rebuilds & Projects.
36
28-09-2015 09:04 AM
DavidK
Ford Sierra/Sapphire/RS500 Cosworth
1
27-09-2015 02:55 PM