Clutch / Flywheel to fit YB to an MTX75 (for FWD or Mid engined use)
#1
Clutch / Flywheel to fit YB to an MTX75 (for FWD or Mid engined use)
All brand new, Im afraid I dont know what the clutch or flywheel are actually from, not sure if its a normal YB flyweel turned down and fitted with zetec ring gear or if its some sort of zetec flywheel or something.
It was in an unfnished mondeo FWD project I bought years ago, and ive never had any use for it.
Clutch is an organic, so probably not much use for huge power, again I know nothing much about it im afraid.
Would certainly do to get someone up and running on a mid engined cossie power if they were just on a stage 3 setup or whatever though im sure.
150 quid posted
#2
Resident Wrestling Legend
iTrader: (3)
it's an xr plate, probably for the 2.9
for your information, the mtx75 will fit the cossie block and use can use the same clutch/flywheel from the cossie as the bellhousing is the same
alternativly, you can keep hold of the cossie flywheel with it's 9 bolts and just bolt on the xr plate and cover, the only thing you will be scratching your head about is the release bearing as there are a few different ones
also, the 2.8 and 2.9 clutches are physically the same size as the cossie one so it all on that side of things as well
for your information, the mtx75 will fit the cossie block and use can use the same clutch/flywheel from the cossie as the bellhousing is the same
alternativly, you can keep hold of the cossie flywheel with it's 9 bolts and just bolt on the xr plate and cover, the only thing you will be scratching your head about is the release bearing as there are a few different ones
also, the 2.8 and 2.9 clutches are physically the same size as the cossie one so it all on that side of things as well
Thread
Thread Starter
Forum
Replies
Last Post
wheelwizardrefurbs
Technical help Q & A
10
04-08-2015 06:23 PM
hazbaz1984
Ford Focus (All Models)
0
30-07-2015 05:15 PM