Group a coil wiring
#1
PassionFord Post Troll
Thread Starter
Group a coil wiring
Hi all
Fitted a group a coil and loom for it a couple of years ago, at the time I never cut out all the old wiring as I didn’t know what I had to keep, going off the picture can anyone tell me how much of this mess the car doesn’t need to run ok? Going to eventually run coil on plug but need to run the engine in first and drive to mapper and not want it arriving looking a mess lol.
what is plpd
im sure I read you keep the green wire And black wire and crisp them on but I have several greens
cheers
Fitted a group a coil and loom for it a couple of years ago, at the time I never cut out all the old wiring as I didn’t know what I had to keep, going off the picture can anyone tell me how much of this mess the car doesn’t need to run ok? Going to eventually run coil on plug but need to run the engine in first and drive to mapper and not want it arriving looking a mess lol.
what is plpd
im sure I read you keep the green wire And black wire and crisp them on but I have several greens
cheers
#3
PassionFord Post Troll
Thread Starter
Where did you take the feed from mate? I have the msd loom that gives it battery voltage, think it takes a feed from the ignition amp but not sure if that’s all.
#4
PassionFord Post Troll
Thread Starter
From this...
To this...
A little bit better, did message stu from msd for advice after all I did buy the coil loom and coil from msd but as per usual no reply.
To this...
A little bit better, did message stu from msd for advice after all I did buy the coil loom and coil from msd but as per usual no reply.
Thread
Thread Starter
Forum
Replies
Last Post
lukeytheduke
General Car Related Discussion.
17
05-07-2011 03:59 PM
IANS2RST
General Car Related Discussion.
43
15-09-2007 06:21 PM
simonc
Ford Sierra/Sapphire/RS500 Cosworth
1
24-05-2007 08:04 PM