Group a coil wiring
 

Hi all

Fitted a group a coil and loom for it a couple of years ago, at the time I never cut out all the old wiring as I didn’t know what I had to keep, going off the picture can anyone tell me how much of this mess the car doesn’t need to run ok? Going to eventually run coil on plug but need to run the engine in first and drive to mapper and not want it arriving looking a mess lol.

https://i.ibb.co/PYVHWhy/87-F47-B1-B...57-CB95863.jpg
what is plpd

im sure I read you keep the green wire And black wire and crisp them on but I have several greens

cheers

Here's mine, it was mess with a few different connections. I pulled it all back and wired it direct.

https://cimg1.ibsrv.net/gimg/passion...83936eadf3.jpg

Where did you take the feed from mate? I have the msd loom that gives it battery voltage, think it takes a feed from the ignition amp but not sure if that’s all.

From this...


https://cimg4.ibsrv.net/gimg/passion...1fc0c62a2.jpeg


To this...

https://cimg2.ibsrv.net/gimg/passion...30d7900ee.jpeg

A little bit better, did message stu from msd for advice after all I did buy the coil loom and coil from msd but as per usual no reply.