Silvertop low temp stat/ fan switch
#1
PassionFord Post Whore!!
Thread Starter
Silvertop low temp stat/ fan switch
Is there a low temperature thermostat & fan switch available for a silvertop zetec?
The following users liked this post:
slammedorion (16-10-2017)
#3
PassionFord Post Whore!!
Thread Starter
Can do if needs be...
It’s a job I want to look into over winter
Fan kicks in and out just over half way which is in the normal area... and with the management I assume it can be adjusted
The temp always goes higher while warming up... as if the thermostat is opening up later than wanted
Once the fan first kicks in higher up the temp range it’ll kick in in the normal position all day long
It’s a job I want to look into over winter
Fan kicks in and out just over half way which is in the normal area... and with the management I assume it can be adjusted
The temp always goes higher while warming up... as if the thermostat is opening up later than wanted
Once the fan first kicks in higher up the temp range it’ll kick in in the normal position all day long
The following users liked this post:
slammedorion (16-10-2017)
#5
PassionFord Post Whore!!
Thread Starter
Looking on Eurocarparts just putting the Reg of the Mondeo I had the engine out of it could be one that opens at 92degs or 88 degs so there’s room for improvement...
I’m pretty sure I used a cvh temp gauge switch... but I’ll try check tomorrow if possible
I’m pretty sure I used a cvh temp gauge switch... but I’ll try check tomorrow if possible
#6
PassionFord Post Whore!!
Thread Starter
That’s a 82 deg
https://www.ebay.co.uk/i/252764910672
Will pull mine out to check towards weekend but we think this should fit
Unless there’s anything available lower?
Fan switch not needed, whatever is in was just calibrated and controlled by the engine management
https://www.ebay.co.uk/i/252764910672
Will pull mine out to check towards weekend but we think this should fit
Unless there’s anything available lower?
Fan switch not needed, whatever is in was just calibrated and controlled by the engine management
#7
Regular Contributor
iTrader: (1)
This one could be an option, it's been a while since i nailed my silvertop zetec turbo together but i'm sure i've got this one fitted in mine, i had to take a bit off the diameter with a file as it was a very tight fit in my early zetec alloy thermostat housing, but you might be able to make it work. all the dimensions are in the listing
http://www.ebay.co.uk/itm/FIESTA-XR2...QAAOSw5cNYWA1J
http://www.ebay.co.uk/itm/FIESTA-XR2...QAAOSw5cNYWA1J
The following users liked this post:
slammedorion (17-10-2017)
Trending Topics
#8
PassionFord Post Whore!!
Thread Starter
I’m using the sh!t brown housing...
Cheers
There’s always something to do on them
Cheers
There’s always something to do on them
Thread
Thread Starter
Forum
Replies
Last Post
AustenW
Technical help Q & A
2
07-08-2004 08:25 PM