Prop Shaft Breakages.
Has anyone broken or seen a broken prop ?
If so where do they fail i.e. on the tube, on the weld between tube and UJ or the UJ itself ? Cheers for any replies. WD :D |
my effort :eek:
https://img.photobucket.com/albums/v...cture888-1.jpg https://img.photobucket.com/albums/v...cture887-1.jpg i think thats when i got the nickname McSnapper :wall: :cry: :cry: |
:eek:
How much power and what conditions ? Looks like the actual tube has failed, If it has then it could do that anywhere along its length, how do I protect against that :? |
was running about 550bhp inc 25 shot of nos, that was the first time i had launched it after fitting ffd 7speed and that gpA prop section you see there, had a HD one made up after that and had no probs :top:
|
My dad did one in his xr4i(rover V8) it twisted and then snapped like a piece of chewing gum, clean in two at 90mph!!
Only the rear exhaust hanger that I made out of 1/2" bar prevented it from dropping onto the floor, it snapped about 6" from gearbox. tabetha |
All times are GMT. The time now is 06:21 PM. |
© 2024 MH Sub I, LLC dba Internet Brands