AN and thread sizes for breather fittings on each side of the block ?
 

Anyone know which sizes ? Pretty sure it's AN -12 but what threads ?

For a WRC breather? the sizes are -10 & -8

My new breather system is an10 from both sides of the block and rocker cover then an10 return to the sump with a one way valve in the line

For a Bailey mirror image one, I've got the AN fittings on the breather but need to know the thread sizes on the block.

Which breather mate ?

Spec r set up like rods. I did have the block thread size as I broght a fitting for my block but it's at marks. I'm sure it was the guy from torques who told me what size it is

Ah right, thanks mate.

Its def -10 turbo side

Cheers mate, what thread sizes though ?

The inlet side doesn't have threads, it's a push in fitting. The exhaust side is 3/8 NPT I believe.

Thanks Paul

The easiest way I found was to use a tap and die set . The pipes are the easy bit it's the adapters you need to screw into whatever your using the hoses for that's the pain in the arse . I found no one really knew what the thread sizes I needed were , so had to find out myself :cry::cry:

Piero at X-Power sells the adaptors for turbo side

James which 1 way valve did you use for the sump?!

The inlet kidney box side is as said a push fit, I also thought that the turbo side was a taper thread from memory but I could be wrong!!!

I'm not too sure I'd have to get it out the garage and have a look in not too sure when I'll next be there. Mark Sheed will know