-beefy-

iTrader: (6)

As title folks , going to put one on the mk three , anyone got any clear pics of the required mods to the bulkhead and more so the clutch arm.

Looking to see what's removed from clutch ( ratchet ect ) position of clevis , size ect.


Just looking to button up my pedal assembly at the weekend so rather do the mods now



Beef

Mark V8

iTrader: (2)

I've got a couple of pictures but all the parts are now buried in the loft with loads of other Sierra bits so sizes will be a problem





Slave cylinder and rose joint from Merlin Motorsport.

You will need to make up a pair of 'top hat' bushes to nip up on the centre part of the rose joint and prevent the pedal from crushing.

The complete ratchet mechanism was taken off and I had to remove a bit of metalwork on the pedal assembly that was in the way, no pics of this though.

-beefy-

iTrader: (6)

Thanks mark

Paul_RS

iTrader: (4)

Pretty sure Rainbum has detailed photos of what needs drilling and where.

-beefy-

iTrader: (6)

Like blood out of a stone that will be Paul !! Lol


He may c this and post

Paul_RS

iTrader: (4)

You got an email address Beefy? Had a look and it turns out i have the instructions here lol.

paul16v

Got a detailed set of pics down the garage Beefy. Might even lend you ther correct size holesaw.

All I ask in exchange is the pics of my underside resto

-beefy-

iTrader: (6)

Bringing them up tomorrow mate as have to pop in and see stormy aswell

BigErn

Helens car is sat at my garage if you need to have a look at owt..... didnt you say you were working in Sunderland now??

-beefy-

iTrader: (6)

I'm off thurs n fri ern , prob bk that way mon buddy

BigErn

Cool beans, its there if you need a nosey. All ya gots to do is holla

eel-roy-t5r

are they any good like ian , been lookin at them for mine

BigErn

Its nice and light but not sure Id spend the money doing it cos Ive always found the cables light enough

-beefy-

iTrader: (6)

I'm thinking for when the missus drives mine lol

Don't suppose u can read the m/c size can u Ian ?

cozzy jeff

iTrader: (4)

any chance you could send them to me please,im looking to do this to mine and would like to cut the hole in the bulk head before going for paint.
cheers jeff

Matt Baxter

iTrader: (37)

I have a hole press/ punch type tool if you need it does a very nice job and much tidier than a hole saw

same sort of thing as this
http://www.ebay.co.uk/itm/RUKO-10935...#ht_500wt_1156

also I can email you the instructions if you like?

BigErn

Ill see if I can see next time Im at the garage dude

-beefy-

iTrader: (6)

if you wouldnt mind matt ill drop u a pm