Help and advice needed from the Gurus please
#1
Help and advice needed from the Gurus please
I bought these drive shafts from the bay (link below) and are trying to find out if they are the real mcoy, a tall order from a picture I know but any advice or tricks to tell I would much appreciate it
The seller said they came out of a scrapped 4x4 saph cos and were kept as spare but then the owner sold his cossie and he sold the shafts on his behalf as the owner was a friend, I asked the question to the seller and he couldn't say for definate only the info as above but offered a refund and was sweet about it,
I didn't pay the earth for them as you can see but if they are not cossie shafts and turn out to be xr4x4 ones I'll aim to sell them on
Help much appreciated
Luciano
http://cgi.ebay.co.uk/ws/eBayISAPI.d...MEWN:IT&ih=025
The seller said they came out of a scrapped 4x4 saph cos and were kept as spare but then the owner sold his cossie and he sold the shafts on his behalf as the owner was a friend, I asked the question to the seller and he couldn't say for definate only the info as above but offered a refund and was sweet about it,
I didn't pay the earth for them as you can see but if they are not cossie shafts and turn out to be xr4x4 ones I'll aim to sell them on
Help much appreciated
Luciano
http://cgi.ebay.co.uk/ws/eBayISAPI.d...MEWN:IT&ih=025
#5
Right then I have done a measure up by laying shafts as as straight as poss by laying on the floor as in pic, one is just short of 25" 62mm and the other is just long of 25" 64mm
measurement taken from tip on splind to splind.
Don't know if this will help
Luciano
measurement taken from tip on splind to splind.
Don't know if this will help
Luciano
#7
PassionFord Post Troll
iTrader: (5)
Join Date: May 2003
Location: Dunstable (Junction 9 or 11 of the M1)
Posts: 3,002
Likes: 0
Received 0 Likes
on
0 Posts
From the small pic it doesn't look like it has the circlip groove on the end of one of the shafts for the drivers side one - you could check that to see if it has
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
wheelwizardrefurbs
Technical help Q & A
10
04-08-2015 06:23 PM