cutch

iTrader: (1)

Bara big tooth gearbox with
Uprated Vc 60Nm
1 x 3.9 Drop Gear
£3000

MK Motorsport Stage 2, 6 degree beam. Sold


Everything has done less than 1000 miles, and is in perfect condition, both are currently on my series 1 and can be viewed / heard / driven etc before taken out if needed. I'm going back to standard drivetrain.



7.5" Gripper Diff, bought new from Bara 1000miles ago with 3.6 crown wheel and pinion, I have had a 4.1 installed by Gears, and new seals were installed at the same time. I still have the 3.6 CW & P so it can be suited to road or track use. I have done one track day and a set up on rolling road with the 4.1 in it since fitting the 4.1. Currently still on my track car and will need removing.

Sold

Caddyshack

Why don't you just mount the beam on rubber bushes where it meets the shell? I dont think the other parts transmit much NVH road noise etc?

I haven't noticed any clonks, vibration or more noise since changing to 6 degree but the handling and geo options are much better?

I understand on the box and diff....good price on the box too!

Harryh24

iTrader: (1)

Hi is there a difference between the 6 degree beam ark usually does? As they are 1k new from him?
Thanks

turbotrev

Thats what i was thinking tbh.
Are you open to offers on the rear beam?

Cheers Paul

jamie's

At least you wont need to wait 6 months for your mk beam

cutch

iTrader: (1)

Beams sold thanks guys.

And MT is selling the beams for £1375 ??

http://mt-motorsport.com/marko/index...ur3m4lsko6ohu7

cutch

iTrader: (1)

Deposit taken on the diff

Sierrasideways

iTrader: (1)

I have seen that. I wonder is that without supplying your own beam as exchange as it says "on stock ready to go" on their site?

cutch

iTrader: (1)

I bought mine without supplying a beam and he sent it overnight. Can't fault mark, had loads from him over the years

eel-roy-t5r

would this box work with standard diffs or would they need changing to 3,9

cutch

iTrader: (1)

Std diff on the front and 3.9 on the rear.

eel-roy-t5r

bit to much for me then atm bud cheers for the info

Caddyshack

Or change the drop gears? They go well on 3.9's too. The cossie is way over geared as standard.

I have 3.9 and close ratio on 16 inch 45 profile tyres and it still does 160 at 8,000 rpm (not that I rev it that high)