zvhturbo

Standard ERST fan switch, what temps should it cut in & out?

Does anyone know, i think mine is buggered, it cuts in at 100degrees

Tony Turbo

92 I think mate

Stat opens at 88, fan at 92 I believe

zvhturbo

Hmmm,

I've stuck an 82 degree stat in for now with a cozy fan switch.

Matt

MikeyXR2i

Anyone got the older type ERST Fan switch off an S1? its the brown one with the Spade type connectors.

Cheers

Tony Turbo

I use an 82 degree stat too

zvhturbo

What fan switch do you use??

rs_daz

cossie fan switch 7001614 red

I got the state too 82 one.. temp never goes over half way now

tonyturbo

would this stat fit a zetec? if not which 1 do i need?

Tony Turbo

I don't. My ECU controls the temperature the fans come in

PPSSSHH

i used to have loads of 52mm gauges in me grey turbo one of wich was a revotech water temp and according to that it used to hit 60 degrees and the fan would come on every time but im told that some after market gauges can be incorect due to some univesal parts

Andrew

Sorry people, i've just been looking for a post liek this, where abouts have you guys got your cossie fan switches from?

Cheers

RS-adam

mine also didn't get over half way, wit the 82 stat and cossie fan switch, but then I put my bumber back on... and know it get over half way some times.... so im cinsidering cuttin out my bumber

Rs_Dave

iv just fitted a 82 degree stat,, its made no difference, to b honest its made it worse!

so were do u get the cossie fan switch from??