Bartheez

I have plenty of room. What inlet setup are you running?

Bransby

Has any1 used the RMD IC?? Watching one on eBay but didn't know if there any good, is it worth changing rad from standard too?? I'm
Just building a new engine for the Rs, big valve head piper cam, acralite low comp pistons and so on was hoping to run around 16psi when new lump goes in so hoping to change rad n IC then. Cheers

gus

iTrader: (1)

im runing throttle bodies so no room for the jenvey

would love one tho as they are very trick indeed

Rogeyboy

iTrader: (2)

Muz - i'll try and get mine to sit tight against each other, but at the moment they are about 15mm apart at one end and 25 the other, can't seem to get them any closer!

lewis.philcox

you need to butcher the brackets and drill new holes slightly lower down




you see where theres a bend in the bracket i got rid of that bend so it was purely flat and flush with the intercooler and then it sat a lot better.. there is a slight gap but my temps never rose above a quarter and under hard load got to just about half but soon settled back down.. that was when she was running about 3 weeks ago